摘要
基于RNG k-ε湍流模型和改进的质量输运空化模型，数值模拟了离心泵内瞬态空化流动。数值计算得到的离心泵临界空化余量值与试验结果吻合较好，验证了数值模型和计算方法的准确性。在离心泵叶轮内叶片吸力面、流道中间及叶片压力面布置监测点，分析叶轮内压力脉动特性及瞬态空泡形态。结果表明：叶轮内压力脉动主频为叶轮转频及其谐频；在叶片吸力面，叶轮内压力脉动最大幅值在距进口4/5处最大，流道中间及叶片压力面，压力脉动最大幅值由进口至出口渐渐增大，在出口处最大。叶轮流道内空泡随时间经历发展，断裂，尾部溃灭的过程；空泡连续的大尺度再生和溃灭造成压力脉动幅值增大，附着型空泡导致压力脉动幅值减小。
Abstract
The transient cavitation flows in a centrifugal pump are numerically simulated by using the modified mass transport cavitation model and RNG k-ε turbulence model. The calculated variation of pump head is in good agreement with the experimental data. The results demonstrate that the numerical model and method can accurately predict the cavitation flows in a centrifugal pump. The characteristics of pressure fluctuation and transient cavity pattern are analyzed. It shown that the dominant frequencies of pressure fluctuations in impeller are the impeller rotating frequency (fi) and its harmonic frequency; the maximum amplitude of pressure fluctuation reaches the largest value at the 4/5 length of the blade suction side from the blade inlet side; from the impeller inlet to outlet, the maximum amplitude of pressure fluctuation in flow passage and blade pressure side gradually increase; the cavity in impeller is developing, breaking and collapsing with the time; the pressure fluctuation amplitude is increasing for large scale regeneration and collapsing of the cavity, and is decreasing for the attached cavity.
基金
国家自然科学基金项目( 51579006) ; 国家自然科学基金项目 ( 51679122 ) ; 北京市自然科学基金项目
( 3164045) ; 内蒙古自治区高等学校科 学研究项目
( NJZY17450)
{{custom_fund}}
王文婷，孟根其其格，路 宏，王 欣.
离心泵瞬态空化流动压力脉动及空泡形态[J].中国农村水利水电, 2017(9): 202-206
WANG Wen-ting，MENG Gen-qiqige，LU Hong，WANG Xin.
Pressure Fluctuation and Cavity Pattern of Transient Cavitation Flow in a Centrifugal Pump[J].China Rural Water and Hydropower, 2017(9): 202-206
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
[1] 李景悦. 混流式叶轮瞬态空化特性研究[J]. 中国农村水利水电，2016，(07):107-111.
[2] 胡全友，刘小兵，赵琴，等. 叶片数及分流叶片对离心泵流场和空化性能的影响[J]. 中国农村水利水电，2016，(04):112-115.
[3] 王福军，张玲，黎耀军，等. 轴流式水泵非定常湍流数值模拟的若干关键问题 [J]. 机械工程学报，2008，44(8):73-77.
[4] Kubota A，Kato H，Yamauchi H，Maeda M. Unsteady structure measurement of cloud cavitation on a foil section using conditional sampling technique [J]. Journal of Fluids Engineering，1989，111(2):204-210.
[5] Pham T M，Larrarte F，Fruman D H. Investigation of unsteady sheet cavitation and cloud cavitation mechanisms [J]. Journal of Fluids Engineering，Transactions of the ASME，1999，121(2):289-296.
[6] 顾巍，何友声. 空泡流非稳态现象的流动控制 [J]. 力学学报，2001，33(1):19-27.
[7] Huang B，Wang G Y. Experimental and numerical investigation of unsteady cavitating flows through a 2D hydrofoil [J]. Technological Sciences，2011，154(7):1801-1812.
[8] Leroux J B，Coutier-Delgosha O & Astolfi J A. A joint experimental and numerical analysis of mechanisms associated to unsteady partial cavitation [J]. Phys. Fluids，2005，17(5)，052101.
[9] Bachert R，Stoffel B，Dular M. Unsteady cavitation at the tongue of the volute of a centrifugal pump [J]. Journal of Fluids Engineering，Transactions of the ASME，2010，132(6):0613011-0613016.
[10] Yao Z F，Wang F J，Xiao R F，et al. Experimental investigation of pressure instabilities affected by cavitation for a double-suction centrifugal pump[C]. IOP Conference Series: Earth and Environmental Science，2012，15(PART 6).
[11] 谭磊，曹树良. 基于滤波器湍流模型的水翼空化数值模拟 [J]. 江苏大学学报(自然科学版)，2010，31(6): 683-686.
[12] 谭磊，曹树良，桂绍波，等. 绕水翼空化流动的数值模拟 [J]. 清华大学学报(自然科学版)，2010，50(7):1058-1062.
[13] 杨敏官，尹必行，康灿，等. 绕水翼非定常空化流场数值模拟 [J]. 排灌机械工程学报，2012，30(2):192-197.
[14] Shi W D，Wang C，Wang W，et al. Numerical calculation on cavitation pressure pulsation in centrifugal pump [J]. Advances in Mechanical Engineering，2014，367631:1-8.
[15] Zhang R，Chen H. Numerical analysis of cavitation within slanted axial-flow pump [J]. Journal of Hydrodynamics，2013，25(5):663-672.
[16] Sato T，Nagahara T，Tanaka K，et al. Vortex cavitation and oscillation in a double-suction volute pump[C]. Timisoara, Romania: Institute of Physics Publishing，2010.
[17] Tan L，Zhu B S，Cao S L，et al. Numerical simulation of unsteady cavitation flow in a centrifugal pump at off-design conditions[J]. Proceedings of the Institution of Mechanical Engineering Part C-Journal of Mechanical Engineering Science，2014，228(11): 1994-2006.
[18] 张德胜，潘大志，施卫东，等. 轴流泵空化流及其诱导压力脉动的数值模拟[J]. 华中科技大学学报(自然科学版)，2014，42(1):34-38.
[19]孟根其其格，谭磊，曹树良，等. 离心泵蜗壳内非定常流动特性的数值模拟及分析[J]. 机械工程学报，2015，51(22):183-190.
[20]谭磊. 离心泵叶轮的优化设计理论及方法研究[D]. 北京：清华大学，2011.
PDF(748 KB)
鄂公网安备 42010602001274号 鄂ICP备14015464号-1